My navigator is a Tomtom One XL.
I'd like to know where I can read the step-by-step procedure to enter
my corrections of the map and then to share those corrections with the
other users. I have been looking hours for that (on Tomtom help as
well as in the web), with no success.
Regards
---
Uplbet

Tap the Main Menu to get Main Menu 1 of 2.
Tap the Arrow on the right hand side to get Main Menu 2 of 2.
Tap Map Corrections at top right hand and follow your nose.
Regards

On Sun, 07 Nov 2010 16:13:43 +0100, Uplbet <(E-Mail Removed)>
wrote:

>My navigator is a Tomtom One XL.
>I'd like to know where I can read the step-by-step procedure to enter
>my corrections of the map and then to share those corrections with the
>other users. I have been looking hours for that (on Tomtom help as
>well as in the web), with no success.
>Regards
>---
>Uplbet

On 08/11/2010 07:54, John wrote:
> Tap the Main Menu to get Main Menu 1 of 2.
> Tap the Arrow on the right hand side to get Main Menu 2 of 2.
> Tap Map Corrections at top right hand and follow your nose.
> Regards
>
> On Sun, 07 Nov 2010 16:13:43 +0100, Uplbet<(E-Mail Removed)>
> wrote:
>
>> My navigator is a Tomtom One XL.
>> I'd like to know where I can read the step-by-step procedure to enter
>> my corrections of the map and then to share those corrections with the
>> other users. I have been looking hours for that (on Tomtom help as
>> well as in the web), with no success.
>> Regards
>> ---
>> Uplbet
>
I seem to remember that the first time you do this you need to be
connected to TomTomHome so the preference can be registered on your account

Il Mon, 08 Nov 2010 15:54:29 +0800, John ha scritto:

>Tap the Main Menu to get Main Menu 1 of 2.
>Tap the Arrow on the right hand side to get Main Menu 2 of 2.
>Tap Map Corrections at top right hand and follow your nose.
>Regards

found it, thanks a lot John.

Now, I wonder what is the type of correction to be expressed in the
following case: at the intersection of street A with street B, a
certain turn left maneuver is not allowed according to my map, while
it is allowed in fact. How would you express such correction on your
navigator?
Best regards
---
Uplbet

Tap Map Corrections
This takes you to a screen with Correct a map error in top left hand
corner
Tap Correct a map error to get Map corrections 1 of 2 screen
Tap Change turn restrictions in bottom left hand corner

Regards
John


On Mon, 08 Nov 2010 11:20:03 +0100, Uplbet <(E-Mail Removed)>
wrote:

>Il Mon, 08 Nov 2010 15:54:29 +0800, John ha scritto:
>
>>Tap the Main Menu to get Main Menu 1 of 2.
>>Tap the Arrow on the right hand side to get Main Menu 2 of 2.
>>Tap Map Corrections at top right hand and follow your nose.
>>Regards
>
>found it, thanks a lot John.
>
>Now, I wonder what is the type of correction to be expressed in the
>following case: at the intersection of street A with street B, a
>certain turn left maneuver is not allowed according to my map, while
>it is allowed in fact. How would you express such correction on your
>navigator?
>Best regards
>---
>Uplbet

Il Tue, 09 Nov 2010 15:35:56 +0800, John ha scritto:

>Tap Map Corrections
>This takes you to a screen with Correct a map error in top left hand
>corner
>Tap Correct a map error to get Map corrections 1 of 2 screen
>Tap Change turn restrictions in bottom left hand corner

super!
Regards
---
Uplbet

"Uplbet" <(E-Mail Removed)> wrote in message
news:(E-Mail Removed)...
> Il Tue, 09 Nov 2010 15:35:56 +0800, John ha scritto:
>
>>Tap Map Corrections
>>This takes you to a screen with Correct a map error in top left hand
>>corner
>>Tap Correct a map error to get Map corrections 1 of 2 screen
>>Tap Change turn restrictions in bottom left hand corner
>
> super!
> Regards
> ---
> Uplbet
Hi all,
Glad to see some activity on this site.
While you are on problem solving mode, I have one. I have a Go 730. One of
the reasons I bought it was its advertised ability to give warning when one
exceeds the speed limit. I wasn't much impressed with its performance in
this and especially as I found only very major highways had speed zones
marked to enable it. So I set about trying, through map corrections, to mark
in the speed limits on the roads I most travelled.
From my reading of the manual I believe I should be able to double tap a
section of the highway - where 80kph starts - and double tap where it
changes to say 60kph. I should then have the highway between the two points
highlighted and can mark them as 80kph.
This does not happen. All a double tap does on my machine is move the cursor
to the double tap point. Entire highways are selected.
Has anyone else attempted this and, if so, with what success.
Cheers,
Dan

On Wed, 10 Nov 2010 21:26:58 +1000, Dan wrote:

> "Uplbet" <(E-Mail Removed)> wrote in message
> news:(E-Mail Removed)...
>> Il Tue, 09 Nov 2010 15:35:56 +0800, John ha scritto:
>>
>>>Tap Map Corrections
>>>This takes you to a screen with Correct a map error in top left hand
>>>corner
>>>Tap Correct a map error to get Map corrections 1 of 2 screen
>>>Tap Change turn restrictions in bottom left hand corner
>>
>> super!
>> Regards
>> ---
>> Uplbet
> Hi all,
> Glad to see some activity on this site.
> While you are on problem solving mode, I have one. I have a Go 730. One of
> the reasons I bought it was its advertised ability to give warning when one
> exceeds the speed limit. I wasn't much impressed with its performance in
> this and especially as I found only very major highways had speed zones
> marked to enable it. So I set about trying, through map corrections, to mark
> in the speed limits on the roads I most travelled.
> From my reading of the manual I believe I should be able to double tap a
> section of the highway - where 80kph starts - and double tap where it
> changes to say 60kph. I should then have the highway between the two points
> highlighted and can mark them as 80kph.
> This does not happen. All a double tap does on my machine is move the cursor
> to the double tap point. Entire highways are selected.
> Has anyone else attempted this and, if so, with what success.
> Cheers,
> Dan

Perhaps you'd get more results if you started a new thread with your
question, especially since your question seems to be unrelated to the
thread you placed it in...

--
Gene E. Bloch (Stumbling Bloch)

Gene E. Bloch wrote:
> On Wed, 10 Nov 2010 21:26:58 +1000, Dan wrote:
>
>> "Uplbet" <(E-Mail Removed)> wrote in message
>> news:(E-Mail Removed)...
>>> Il Tue, 09 Nov 2010 15:35:56 +0800, John ha scritto:
>>>
>>>> Tap Map Corrections
>>>> This takes you to a screen with Correct a map error in top left
>>>> hand corner
>>>> Tap Correct a map error to get Map corrections 1 of 2 screen
>>>> Tap Change turn restrictions in bottom left hand corner
>>>
>>> super!
>>> Regards
>>> ---
>>> Uplbet
>> Hi all,
>> Glad to see some activity on this site.
>> While you are on problem solving mode, I have one. I have a Go 730.
>> One of the reasons I bought it was its advertised ability to give
>> warning when one exceeds the speed limit. I wasn't much impressed
>> with its performance in this and especially as I found only very
>> major highways had speed zones marked to enable it. So I set about
>> trying, through map corrections, to mark in the speed limits on the
>> roads I most travelled.
>> From my reading of the manual I believe I should be able to double
>> tap a section of the highway - where 80kph starts - and double tap
>> where it changes to say 60kph. I should then have the highway
>> between the two points highlighted and can mark them as 80kph.
>> This does not happen. All a double tap does on my machine is move
>> the cursor to the double tap point. Entire highways are selected.
>> Has anyone else attempted this and, if so, with what success.
>> Cheers,
>> Dan
>
> Perhaps you'd get more results if you started a new thread with your
> question, especially since your question seems to be unrelated to the
> thread you placed it in...

Its not unrelated, it involves correcting maps, and thats a fundamental part of map share.

On Fri, 12 Nov 2010 05:37:21 +1100, Rod Speed wrote:

> Gene E. Bloch wrote:
>> On Wed, 10 Nov 2010 21:26:58 +1000, Dan wrote:
>>
>>> "Uplbet" <(E-Mail Removed)> wrote in message
>>> news:(E-Mail Removed)...
>>>> Il Tue, 09 Nov 2010 15:35:56 +0800, John ha scritto:
>>>>
>>>>> Tap Map Corrections
>>>>> This takes you to a screen with Correct a map error in top left
>>>>> hand corner
>>>>> Tap Correct a map error to get Map corrections 1 of 2 screen
>>>>> Tap Change turn restrictions in bottom left hand corner
>>>>
>>>> super!
>>>> Regards
>>>> ---
>>>> Uplbet
>>> Hi all,
>>> Glad to see some activity on this site.
>>> While you are on problem solving mode, I have one. I have a Go 730.
>>> One of the reasons I bought it was its advertised ability to give
>>> warning when one exceeds the speed limit. I wasn't much impressed
>>> with its performance in this and especially as I found only very
>>> major highways had speed zones marked to enable it. So I set about
>>> trying, through map corrections, to mark in the speed limits on the
>>> roads I most travelled.
>>> From my reading of the manual I believe I should be able to double
>>> tap a section of the highway - where 80kph starts - and double tap
>>> where it changes to say 60kph. I should then have the highway
>>> between the two points highlighted and can mark them as 80kph.
>>> This does not happen. All a double tap does on my machine is move
>>> the cursor to the double tap point. Entire highways are selected.
>>> Has anyone else attempted this and, if so, with what success.
>>> Cheers,
>>> Dan
>>
>> Perhaps you'd get more results if you started a new thread with your
>> question, especially since your question seems to be unrelated to the
>> thread you placed it in...
>
> Its not unrelated, it involves correcting maps, and thats a fundamental part of map share.

Not shared, just his own maps.

--
Gene E. Bloch (Stumbling Bloch)